Placing in speakers is a fantastic way to improve the standard of your vehicle's stereo system! Here is any easy-to-follow guide that will assist you get through the crucial steps of your car speaker setup.
Before beginning your job, don't forget to read the directions for your particular car speakers.
To set up new door speakers, then use a popping instrument to thoroughly remove the front door ; once this is completed, disconnect the older speaker and then lift it from the doorway.
Prep that the for setup by heating it up using a heating. Apply spray adhesive to the part of this doorway you are going to be installing the matting on, and then pare off the backing.
Working with the heating again, steadily guide hot air in the as you put in it to the doorway surface. Immediately following the was implemented, go over it completely using a roller to ensure a tight bond. Position the speaker at the door , then secure it with screws.
STEP 1 Before you begin your project, remember to read the instructions for your specific car speakers.
STEP 2 To install new door speakers, use a popping tool to carefully remove the front door panel; after this is done, disconnect the old speaker and lift it out of the door.
STEP 3 Prep the Dynamat® for installation by warming it up with a heat gun. Apply spray adhesive to the section of the door you'll be installing the matting onto, then peel off the Dynamat's® backing.
STEP 4 Using the heat gun again, steadily direct hot air at the Dynamat® as you install it to the door's surface. Immediately after the Dynamat® has been applied, go over it thoroughly with a roller to ensure a tight bond.
STEP 5 Position the new speaker in the door cavity, and then secure it with screws. STEP 6 Attach the cables that connect the automobile radio/CD participant to the speakers. Add the"positive" cables to the corresponding"favorable" vents in both the speakers and radio, and then plug in the"negative" cable to the"side" ports.
STEP 7 To set up rear speakers, remove the grilles and eliminate the previous speakers; substitute the new ones.
STEP 8 Cable that the back speakers at the exact same manner as the doorway speakers, hammering positive speaker cables into favorable ports, and damaging wires into ports that are negative.
STEP 9 Replace door panels at front, along with grilles from the back.
STEP 10 To Cover Exposed Speaker Wires... We strongly advise that you pay any exposed cable on your stereo system using cable loom, braided sleeving, or heat shrink tube. Not only can your speaker cables be shielded from materials, automotive fluids and abrasion, they will also look good! The product that you choose dictates how and at what stage in the speaker setup procedure you will want to use the cable covering.